The force transducer works according to the strength measuring principle on a transverse basis to the longitudinal axis.

Got to the PBB-10A special for measuring small strengths (quality control, weight and filling level determination, ...) to robot, handling and medical engineering develops.

It is executed as a beam with a chamber. The beam shape and two boreholes with 3,2 mm of diameters permit an assembly suitable for mechanical engineerings. The strength introduction is carried out via further borehole with 4,3 mm of diameters.

The applizierte strain gauge in the chamber is spilled with a very elastic mass and protected so from mechanical and chemical damages.

The strain gauge bridges measure the deformation caused by bend strengths on the beam. An external amplifier (connection to the PBB-10A with approx. 1,5 m of cables) gives a measuring signal between 1 and 9 mA or 4 and 20 mA impressed current.

In the unloaded state can by add-ons of the calibrating checking signal (software calibration) the calling himself nominal output current be produced. A check of the sensor with amplifier and the following measuring facilities is possible with that.

The force transducer is also without amplifiers with a 350 W strain gauge bridge (optional 1000 W ) deliverable.

The PBB-10A is assigned for the direct coupling to an automatic control.