The compression force transducer DKA-30 serves for the grabbing of axial pressure strengths.

Use is carried out for including static and dynamic strengths to springs, platforms, press etc.

The robust form makes a universal use possible under rough conditions in the industry.

The DKA-30 works according to the compressing cylinder principle. The force introduction is alone carried out via the foot plate and the warped end wall.

The application room for the strain gauge (dms) is spilled with a very elastic mass and therefore protected from mechanical and chemical damages.

A strain gauge-full bridge includes the deformation of the bolt which arises from pressing together.

The strap balance is on coordinated approx. ±0,01 mV / V in the unloaded state.

The DKA-30 is provided for the connection to an amplifier.