The force transducer SZ-62 serves for the taking of axial pressure strengths. The robust form makes a universal use possible under rough conditions in the industry.

Use is carried out for including of static and dynamic strengths in axial direction to feathers, screw connections, presses etc.

It works according to the compressing cylinder principle. With him weight strengths, one pressing strengths and friction strengths can be measured. The strength introduction is alone carried out via compressing tube foot and end wall. The force transducer can get prestressed like a washer.

The application room for the stretching measuring stripe (strain gauge) is offered protection against chemical and mechanical charges with one of a very elastic mass.

The strain gauge full bridges measure this one for appeared deformations for the cylinder by the compression. The output signal of the bridge has approx. 0,1 mV / V sensitivity (was measured) at a operating voltage of 5 to 12 V DC.