Applications & Information
The load pin works according to the principle of the clipping strength measuring crossways to the longitudinal axis
The SKL-100 was developed especially by work stages, cranes and promoting technology for use at hydraulics cylinders.
It is executed as a round bolt with two measuring chambers. A notch of 15 mm of breadth and 15 mm of depth serves for the fastening for a locking plate.
The application room for the strain gauge (dms) is spilled with a very elastic mass and therefore protected from mechanical and chemical damages.
DMS-full bridges measure the deformation caused by clipping strengths on the bolt in the measuring chamber. An integrated amplifier delivers the measuring signal from 4 to 20 mA.
In the unloaded state can by add-ons of the calibrating checking signal (software calibration) the nominal output current be produced. A check of the load pin with the amplifier and the following measuring facilities is possible with that.
The SKL-100 is provided for the direct coupling to an automatic control or a controlling switch.
download data sheet (example):