The force transducer is suitable for the measuring of static and dynamic train and pressure strengths, at high precision and low measurements. It works according to the principle of the clipping strength measuring crossways to the longitudinal axis.

The DZA-46 is suitable for use to pondering technology, load measuring to platforms, deciding of kick loads etc.

It is executed as a z/s shaped beam with a measuring cell. The beam shape and two threads M12 on the upper and underside permit a simple assembly and strength introduction.

The application room for the strain gauge is spilled with a very elastic mass and protected so from mechanical and chemical damages.

The strain gauge bridges measure in the measuring cell the caused deformation by clipping strengths on the force transducer. An integrated amplifier delivers a measuring signal between 1 and 9 mA or between 4 and 20 mA impressed current. The calibration is carried out by use of a resistor, parallel connected with a strain gauge bridge (software calibration).

The DZA-46 is provided for the direct connection to a automatic control or a controlling switch.