The force transducer is useable for tension or compression and works according to the strength measuring principle on a transverse basis to the longitudinal axis.

The DZA-60A are suitable for use to pondering technology, load measuring to platforms, deciding of kick loads etc.

It is executed as a z/s shaped beam with a measuring cell. The beam shape and two screw threads M12 on the upper and underside permit a simple assembly and strength introduction.

The application room for the strain gauge is spilled with a very elastic mass and protected so from mechanical and chemical damages.

The strain gauge bridges measure the deformation caused by clipping strengths on the beam in the measuring cell. An external amplifier (connection to the DZA-60 A with approx. 0,5 m of cables) delivers the measuring signal between 1 and 9 mA or between 4 and 20 mA impressed current. The calibration is carried out by use of a resistor, parallel connected with a strain gauge bridge (software calibration).

The DZA-60A is assigned for the direct coupling to an automatic control or a controlling switch.