The force transducer works according to the strength measuring principle on a transverse basis to the longitudinal axis.

It is suitable for measuring of tension and compression forces.

The LBA-120A is universal usable and find used by the measurement from pulling forces at metal hoist, handling for heavy workpieces and robots.

The LBA-120A consist of a beam shear force transducer, on under- and topside is two equal in size flanged with respective four M10 screw threads. The mounting different flanged is possible.

The measuring cell for the strain gauge has been cast with a high-elastic compound and is thus protected against mechanical or chemical damages.

The strain gauge bridges measure the caused deformation in the measuring cell due to the shear forces at the beam. An integrated amplifier gives a measuring signal between 1 and 9 mA or between 4 and 20 mA. The calibration is carried out by use of a resistor, parallel connected with a strain gauge bridge (software calibration).

The zero point from the amplifier is adjusted in series balanced in the middle of the load area. This permit the sensor measuring similarly in pulling and pressure direction.

The LBA-120A is assigned for the direct coupling to an automatic control or a controlling module.

As evaluation unit is suitable the load limitation VELOMAT - VKS-0053.