The force transducer is useable for tension or compression and works according to the principle of the bend strength measuring.

The DZA-24A are suitable for use to pondering technology, load measuring to platforms, deciding of kick loads etc.

It is executed as a z/s shaped bend beam with a measuring cell. The beam form and two screw threads M5 on the upper and underside permit a simple assembly and strength introduction. It allows the measuring of train and pressure strengths.

The application room for the strain gauge is spilled with a very elastic mass and protected so from mechanical and chemical damages.

The strain gauge bridges measure the deformation caused by bend strengths on the beam in the measuring cell.

The DZA-24A is for the direct connection to an amplifier scheduledly (e.g. VELOMAT - VMV-0010).

The cable length between sensor and amplifier amounts to max. 2 m.